Доброго времени суток.
Есть потребность использовать Кали как Whonix Workstation через шлюс Whonix Gateway.
на офф сайте (https:// www. whonix. org/wiki/Other_Operating_Systems) написано как это реализовать, но видимо руки кривые...
Делал все вот так:
Open /etc/network/interfaces in an editor with root rights.
If you are using a graphical Whonix or Qubes-Whonix, run:
kdesudo kwrite /etc/network/interfaces
If you are using a terminal-only Whonix, run:
sudo nano /etc/network/interfaces
You only need to configure eth0:
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface, leave as it is
auto lo
iface lo inet loopback
auto eth0
#iface eth0 inet dhcp
iface eth0 inet static
# increment last octet of IP address on additional workstations
address 10.152.152.12
netmask 255.255.192.0
#network 10.152.152.0
#broadcast 10.152.152.255
gateway 10.152.152.10
In your Custom-Workstation. Open /etc/resolv.conf in an editor with root rights.
If you are using a graphical Whonix or Qubes-Whonix, run:
kdesudo kwrite /etc/resolv.conf
If you are using a terminal-only Whonix, run:
sudo nano /etc/resolv.conf
and delete everything, then add
nameserver 10.152.152.10
ничего не вышло... помогите пожалуйста
Есть потребность использовать Кали как Whonix Workstation через шлюс Whonix Gateway.
на офф сайте (https:// www. whonix. org/wiki/Other_Operating_Systems) написано как это реализовать, но видимо руки кривые...
Делал все вот так:
Open /etc/network/interfaces in an editor with root rights.
If you are using a graphical Whonix or Qubes-Whonix, run:
kdesudo kwrite /etc/network/interfaces
If you are using a terminal-only Whonix, run:
sudo nano /etc/network/interfaces
You only need to configure eth0:
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface, leave as it is
auto lo
iface lo inet loopback
auto eth0
#iface eth0 inet dhcp
iface eth0 inet static
# increment last octet of IP address on additional workstations
address 10.152.152.12
netmask 255.255.192.0
#network 10.152.152.0
#broadcast 10.152.152.255
gateway 10.152.152.10
In your Custom-Workstation. Open /etc/resolv.conf in an editor with root rights.
If you are using a graphical Whonix or Qubes-Whonix, run:
kdesudo kwrite /etc/resolv.conf
If you are using a terminal-only Whonix, run:
sudo nano /etc/resolv.conf
and delete everything, then add
nameserver 10.152.152.10
ничего не вышло... помогите пожалуйста
